dinsdag 13 mei 2014


First we decided to make the case, using a vacuum forming process. This because it's relative easy and cheap at school. Nevertheless these advantages it's not the best solution for our case because the accuracy isn't that good; this resulted in a gap inbetween the two halves.

After the photo session of our product we had the feedback to use another process to form our case to become a good finish of the case. A suggested method was using the lasercutter.
Finally we decide to go for a lasercutted ABS case (with the experience we have to bend materials using the lasercutter, we'll try to make a nice case in this way). These are the illustrator drafts for the lasercutter:

Geen opmerkingen:

Een reactie posten